- Over 1,000 McLaren GTs are recalled due to potential hood latch failure while driving.
- The hood may strike the windshield if the latches fail during operation.
- Dealers will replace the faulty hood latches with a new design to ensure safety.
More than 1,000 McLaren GT models are being recalled in the United States due to a concerning issue with the hood latch that could potentially cause it to fly open while the vehicle is in motion. This situation poses a significant danger not only for the fortunate few who have the privilege of driving the GT but also for other motorists sharing the road.
According to McLaren, the problem lies in the manual release cable of the latch, which may be under excessive tension. As a result, both the primary and secondary latches could inadvertently open. If this occurs while the mid-engined Grand Tourer is moving, the hood could strike the windshield near the hinge points, likely remaining in an upright position and severely limiting visibility for the driver.
Read: New McLaren GTS Features More Power, Less Weight And Extra Practicality
The recall notice further indicates that the excessive tension in the cable may stem from a combination of factors, including damage to the cable itself, improper cable routing, or issues with the assembly of the release lever.
All in all, a total of 1,012 McLaren GT models are affected, specifically those sold between the 2020 and 2023 model years. These vehicles were assembled from September 12, 2019, to May 19, 2023. Notably, a revised design was introduced after this date, meaning that later GTs are not impacted by this issue, nor are any other McLaren models currently in production.
Future Actions for Owners and Dealers
Both dealers and owners of the 2020-2023 McLaren GTs will receive notifications about the recall “in due course.” However, the British automaker has yet to provide any specific dates for this communication. Dealers will be instructed to replace the bonnet latch with a new version that features a longer cable and an updated loop cable release method, in contrast to the lever design of the recalled component.
